User's Manual
Table Of Contents
- Introduction of Epoch-M1P
- Overview
- Warnings and Hazards
- Epoch-M1P Parts List
- Epoch-M1P Software Installation and Requirements
- 1.4.1 Minimum PCS Requirements
- 1.4.2 Epoch-M1P Software Installation
- ** Refer to the Software Setup Guide
- ** Refer to the USB Setup Guide
- Pre-Installation using Epoch-M1P Software
- Step by Step Instructions for Installation
- User Manual V1.0 using Epoch-M1P Software
- Menu Structure
- Using the Epoch-M1P Software
- Alarms
- Default Control Settings
- Maintenance Guide for Epoch-M1P
- Periodic Inspection Checklist
- Preventive Measures for Optimal Operation
- Troubleshooting
- Tx & Rx LEDs
- Common Installation Problems
- Warranty and Repair Policy
- General Warranty
- Limitations of Warranty
Epoch-M1P RF Repeater
User Manual V1.0
Soft Fail Alarm Operation
Soft Alarm Operation
SOFT FAIL ALARM
DOWNLINK RSSI
Power Off
Initializing....
POWER VFD ALARM
6 sec
16 sec
Booting Time
Power On
(off) (off)
POWER VFD ALARM
(Green) (Red)
If the VFD button
is clicked, the
display will be
come up again.
Display Cycle*
POWER VFD ALARM
(Green) (Red)
POWER VFD ALARM
(Green) (Red)
POWER VFD ALARM
(Green) (Red)
The VFD display will
be disappeared 30
minutes later since
the VFD button is
touched.
4 sec
4 sec
Until the
condition
cleared
Advanced RF Technologies, Inc. Proprietary Document Page 36 of 38