User's Manual
Table Of Contents
- Introduction of Epoch-M1P
- Overview
- Warnings and Hazards
- Epoch-M1P Parts List
- Epoch-M1P Software Installation and Requirements
- 1.4.1 Minimum PCS Requirements
- 1.4.2 Epoch-M1P Software Installation
- ** Refer to the Software Setup Guide
- ** Refer to the USB Setup Guide
- Pre-Installation using Epoch-M1P Software
- Step by Step Instructions for Installation
- User Manual V1.0 using Epoch-M1P Software
- Menu Structure
- Using the Epoch-M1P Software
- Alarms
- Default Control Settings
- Maintenance Guide for Epoch-M1P
- Periodic Inspection Checklist
- Preventive Measures for Optimal Operation
- Troubleshooting
- Tx & Rx LEDs
- Common Installation Problems
- Warranty and Repair Policy
- General Warranty
- Limitations of Warranty
Epoch-M1P RF Repeater
User Manual V1.0
Appendix A: Specifications
ELECTRICAL SPECIFICATIONS
PARAMETERS SPECIFICATIONS COMMENTS
DL 1930 to 1990 MHz Frequency
Range
UL 1850 to 1910 MHz
Sub Band Filtering One 5 MHz Sliding Block Model 1
Sub Band Filtering One 10 MHz Sliding Block Model 2
Sub Band Filtering One 15 MHz Sliding Block Model 3
Sub Band Filtering Special Custom Band(s) Model 4
Operating Frequency Programmable Freq. Step: 10 KHz
Frequency Error ≤ +/- 0.1 ppm
Delay ≤ 5 usec Each Direction
Input Dynamic Range -35 to -60 dBm
Repeater Gain 55 to 80 dB
Maximum DL&UL Output Power +20 dBm Composite
DL AGC Range 25 dB /0.5 dB Step
UL AGC Range 25 dB /0.5 dB Step
Gain Flatness +/- 2.5 dB
≤ -45 dBc @ Fc +/- 885 KHz
In Band Noise
≤ -50 dBc @ Fc +/- 1.98 MHz
Spurious Emission < -13 dBm @ Fc +/- 2.25 MHz
Rho Factor ≥ 0.912
Noise Figure ≤ 8 dB
VSWR ≤ 1.5:1
Advanced RF Technologies, Inc. Proprietary Document Page 33 of 38