User's Manual

Epoch-M1P RF Repeater
User Manual V1.0
Figure 9 - Install Window of the Epoch-M1P Software
Band
As shown on Figure 9, click on “Band Selection” button and a new pop-up
window will appear as shown in Figure 5. Select the desired band(s) or
channel number(s) by clicking the appropriate buttons. You can deselect
the undesired band(s) or channel number(s) by clicking the button again.
There are two ways of selecting the operating band(s): (1) you can click
on the partial/full band itself (e.g. A1, B, E, etc.) or (2) you can click on
the specific channel number (e.g. 100, 125, 325, etc.).
The following Table 5 illustrates the channel numbers associated with
each partial/full band. For example, if the Epoch-M1P-05 model which
uses the 5 MHz sliding filter is being used, then in order to choose the B2
band, you would have to click on the center channel number from the
chart below, which is channel number 550.
Similarly, if the Epoch-M1P-15 model which uses the 15 MHz sliding
filter is being used, then in order to select C band, you would have to
click on the channel number 1050 which is the center channel number of
the C band. The following table illustrates the channel numbers assigned
to the partial PCS bands.
Band Partial Band (5 MHz each) Channel Numbers
A1 25, 50 & 75
A2 125, 150 & 175
A
A3 225, 250 & 275
Advanced RF Technologies, Inc. Proprietary Document Page 21 of 38