User's Manual
Table Of Contents
- Introduction of Epoch-M1P
- Overview
- Warnings and Hazards
- Epoch-M1P Parts List
- Epoch-M1P Software Installation and Requirements
- 1.4.1 Minimum PCS Requirements
- 1.4.2 Epoch-M1P Software Installation
- ** Refer to the Software Setup Guide
- ** Refer to the USB Setup Guide
- Pre-Installation using Epoch-M1P Software
- Step by Step Instructions for Installation
- User Manual V1.0 using Epoch-M1P Software
- Menu Structure
- Using the Epoch-M1P Software
- Alarms
- Default Control Settings
- Maintenance Guide for Epoch-M1P
- Periodic Inspection Checklist
- Preventive Measures for Optimal Operation
- Troubleshooting
- Tx & Rx LEDs
- Common Installation Problems
- Warranty and Repair Policy
- General Warranty
- Limitations of Warranty
Epoch-M1P RF Repeater
User Manual V1.0
2 User Manual V1.0 using Epoch-M1P Software
2.1 Menu Structure
2.1.1 Window Overview
Status
The Status Window allows
you to monitor the current
settings and status of the
Epoch-M1P.
Control
The Control Window enables
you to change or adjust the
Epoch-M1P’s parameters
and settings.
Install
The Install Window guides you
through an automated
installation of the Epoch-M1P
repeater.
System Information
For more detailed system information, click on the
Info. Menu. Information such as model number,
serial number, firmware version and manufacturing
date of the repeater are included here
.
Figure 5 - Status Window of the Epoch-M1P Software
Advanced RF Technologies, Inc. Proprietary Document Page 15 of 38