User's Manual

Epoch-M1P RF Repeater
User Manual V1.0
Figure 4 – Band Selection Window of the Epoch-M1P Software
11. Select the Desired Band(s)
From the Install Window (Figure 3), click on “XX MHz Band Selection”
button and a new pop-up window will appear (Figure 4). Select the
desired band(s) or center channel number(s) by clicking the appropriate
buttons. You can deselect the undesired band(s) or channel number(s) by
clicking the button again.
There are two ways of selecting the operating band(s): (1) you can click
on the partial/full band itself (e.g. A1, B, E, etc.) or (2) you can click on
the specific channel #’s (e.g. 100, 125, 325, etc.).
** Depending on whi h model of Epoch-M1P is being used, the band
selection window will vary.
c
** If a wireless modem is not connected, skip steps 12 through 13 and
proceed to step 14.
12. Provide SNMP Information
Type in the Site ID and the Manager IP address as given to you by the
Wireless Provider. Once both the parameters are typed in, you must click
“Set” for it to be executed.
13. Check the Modem Connection
Verify that the
Auto Connection box is checked.
14. Click on Install
After the first three steps, click on “Install.” This installation process will
normally take less than a minute.
Advanced RF Technologies, Inc. Proprietary Document Page 13 of 38