User's Manual
Epoch-S02-19001W RF Repeater
User Manual V1.0
Advanced RF Technologies, Inc. Proprietary Document Page 8 of 32
1.3 Tools and Recommendations for Installation
The following may be necessary (not required) for installation of the repeater:
a. Crescent Wrench
b. Philips Screw Driver
c. Lift, Ladder, or Boom Truck
d. Spectrum Analyzer
e. Sweep Tester
f. Signal Generator
g. Pilot Scanner
h. RF Power Meter
i. Voltmeter
j. Coaxial Cables
k. Compass
l. PC with an RS-232 serial port (with Epoch-S02 1W OMS V1.XX Software
installed)
The list above may vary depending on if brackets are used to install the repeater.
Bring additional tools that may be useful during installation. It is recommended
that two people install the Epoch-S02-19001W repeater system.
1.4 Epoch-S02-19001W Parts List
The Epoch-S02-19001W repeater system includes:
PART ID
QUANTITY
a. Epoch-S02-19001W Repeater EPOCHSO201 1
b. Repeater I-Bracket (Added Option) ISRB01 1
c. Nuts and Bolts BLTS01 4
d. Screws (Added Option) SC01 8
e. Epoch-S02 1W OMS V1.XX SO2OMS V1.XX01 1
f. Ground Cable GNDSTD01 1
Operating the Epoch-S02-19001W with antennas in
very close proximity facing each other could lead to
severe damage to the repeater.
WARNING!