User's Manual
Table Of Contents
- Installation Guide for Epoch-S02
- Environmental requirements
- Warnings and Hazards
- Tools and Recommendations for Installation
- Epoch-S02 Parts List
- Step by Step Instructions for Installation
- User Manual V1.1 using OMS V4.01
- Menu Structure
- Using the Epoch-S02 OMS V4.01
- Alarms
- Default Control Settings
- Maintenance Guide for Epoch-S02 OMS V4.01
- Periodic Inspection Checklist
- Preventive Measures for Optimal Operation
- Troubleshooting
- Epoch-S02 OMS V4.01 Scenarios
- Heartbeat Scenarios
- Warranty and Repair Policy
- General Warranty
- Specific Product Warranty Instructions
- A.1 Minimum Requirements
- A.2 Epoch-S02 OMS V4.01 Installation/Startup
- Appendix B: Specifications
Epoch-S02 RF Repeater
User Manual V1.1
1.3 Tools and Recommendations for Installation
The following may be necessary (not required) for installation of the repeater:
1. Crescent Wrench or drill with drill bit attachment of …
2. Philips Screw Driver
3. Lift, Ladder, or boom truck
4. Spectrum Analyzer
5. Sweep Tester
6. Signal Generator
7. Pilot Scanner
8. RF Power Meter
9. Voltmeter
10. Coaxial cables
11. Compass
12. Laptop or PC with an RS-232 serial port (with Epoch-S02 OMS V4.01
Software installed)
The list above may vary depending on if brackets are used to install the repeater.
Bring additional tools that may be useful in installation. It is recommended that
two people install the Epoch-S02 Repeater system.
Please maintain a safe distance of 27 cm while operating near the donor and the
server antennas (Assuming the maximum gain of either of the antennas do not
exceed 15 dBi).
MPE WARNING!
Operating the Epoch-S02 with antennas in very close
proximity facing each other could lead to severe
damage to the repeater.
WARNING!
Advanced RF Technologies, Inc. Proprietary Document Page 8 of 31