User's Manual
Table Of Contents
- Installation Guide for Epoch-S02
- Environmental requirements
- Warnings and Hazards
- Tools and Recommendations for Installation
- Epoch-S02 Parts List
- Step by Step Instructions for Installation
- User Manual V1.1 using OMS V4.01
- Menu Structure
- Using the Epoch-S02 OMS V4.01
- Alarms
- Default Control Settings
- Maintenance Guide for Epoch-S02 OMS V4.01
- Periodic Inspection Checklist
- Preventive Measures for Optimal Operation
- Troubleshooting
- Epoch-S02 OMS V4.01 Scenarios
- Heartbeat Scenarios
- Warranty and Repair Policy
- General Warranty
- Specific Product Warranty Instructions
- A.1 Minimum Requirements
- A.2 Epoch-S02 OMS V4.01 Installation/Startup
- Appendix B: Specifications
Epoch-S02 RF Repeater
User Manual V1.1
Heartbeat
Heartbeat is a periodic message sent out to Sprint PCS’ NOC.
Heartbeat On/Off Set Heartbeat Mode ON/OFF
Heartbeat Time Set Heartbeat Time 1 ~ 60 min @ 1 min Steps
Table 2.1.3.3 Heartbeat Mode and Time Ran
g
e
Heartbeat Mode
The Heartbeat ON box is enabled by default.
Periodic Time
The Periodic Time is the time interval between Heartbeats. The default time is
20 minutes.
2.1.4 Install Menu
At the time of installation, the installer/technician needs to open the Install Menu
of the Epoch-S02 OMS V4.01. The Install Menu will guide the
installer/technician through a step by step process to properly install the Epoch-
S02 Repeater.
For setup or installation of a repeater, click “Install”
on the menu bar of the Main
Window.
Figure 2.1.4 Install Window of the Epoch-S02 OMS V4.01
Advanced RF Technologies, Inc. Proprietary Document Page 19 of 31