User's Manual
Table Of Contents
- Installation Guide for Epoch-S02
- Environmental requirements
- Warnings and Hazards
- Tools and Recommendations for Installation
- Epoch-S02 Parts List
- Step by Step Instructions for Installation
- User Manual V1.1 using OMS V4.01
- Menu Structure
- Using the Epoch-S02 OMS V4.01
- Alarms
- Default Control Settings
- Maintenance Guide for Epoch-S02 OMS V4.01
- Periodic Inspection Checklist
- Preventive Measures for Optimal Operation
- Troubleshooting
- Epoch-S02 OMS V4.01 Scenarios
- Heartbeat Scenarios
- Warranty and Repair Policy
- General Warranty
- Specific Product Warranty Instructions
- A.1 Minimum Requirements
- A.2 Epoch-S02 OMS V4.01 Installation/Startup
- Appendix B: Specifications
Epoch-S02 RF Repeater
User Manual V1.1
2.1.2 Status Menu
The Status Menu is the monitoring window of the Epoch-S02 OMS V4.01.
This window enables the user to monitor the status and settings of the
Epoch-S02. In other words, no parameters can be changed in the Status
Window. To change parameters, use the Control Menu Option.
Band Selection
Currently selected bands
are highlighted.
Repeater Input
Indicates Input
Signal Strength of
the Repeater after
being amplified by
the donor antenna
[dBm].
Repeater Output
The output of the
repeater [in dBm]
before being radiated
by the server or
coverage antenna.
Repeater Gain
Indicates the gain
of the repeater
expressed [in dB].
Alarm (Button)
The Alarm Button changes color
to the corresponding status of
the repeater: green for Normal
Operation; yellow for Soft
Failure; and red for Hard Failure.
Click on the Alarm button for
detailed information.
White Screen
In this window, the USER will be able to see
heartbeat messages which are sent out periodically.
Additionally, the USER will also be able to see any
alarms that are generated along with messages
once the alarms are cleared as well.
Status Bar
Displays the status of the repeater (Status
Response Success), transmit (TX) and receive
(RX) communication lights, and Com port
(COM1). The Com Port may be changed by
clicking on the arrow next to the COM
selection window.
Figure 2.1.2 Main Status Window of the Epoch-S02 OMS V4.01
Installed
Lets you know if the
repeater is properly
installed or not.
Modem
Connection
PPP connection of
the modem
Clear
Will clear the
White Screen
Log File
Text File for the
heartbeat messages
and alarm status of
the repeater
Advanced RF Technologies, Inc. Proprietary Document
Page 15 of 31