User Manual
Verizon Wireless MPE25K RF Repeater
User Manual V0.3
Advanced RF Technologies, Inc. Proprietary Document 16/59
2.3 Installation
2.3.1 Tools
No special tools or equipment are needed to install the ADRF-25K.
2.3.2 Procedure
Four mounting holes are located on the wall-mounting bracket to attach it to the
wall. The wall bracket must be securely attached to sufficiently carry the weight
of the ADRF-25K, which is bolted to the wall bracket through the four aligned
mounting holes.
The following steps should be followed while mounting the repeater:
Installation Procedure
① Verify that the Repeater and Mounting Bracket are in good condition.
② Drill holes in the installation surface and insert the anchor bolts.
③ Set the mounting bracket against the wall.
④ Using the Hooks on top, set the Repeater against the mounting bracket.
⑤ Using the anchor bolts attach the Repeater to the Bracket.
⑥ Make sure the Repeater is securely attached.
⑦ Connect the GND cable.
⑧ Connect the Antenna cable.
⑨ Connect the Power.
⑩ Using a laptop, install the Repeater.