User's Manual

8
71 42 3 5 6 8
4. Function Settings
A. TRANSMITTER HANDSET
1. System Channel Settings
Fig. 07
Set the transmitter channel simply by adjusting the channel dip-switch located on the backside of the
transmitter encoder board. The system channel table located on page 19 will tell you which dip setting
correspond to which channel. Do make sure that when you change the channel of the transmitter you
must also change the channel of the receiver as well. The channel on both transmitter and receiver must
be identical in order for the system to work.
Example:
Top slot ? “1”
(Fig. 08) Bottom slot ? “0”
The above dip setting would be “100100”, which corresponds to “channel 36” in the system
channels table on page 19.
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
CHANNEL FUNCTION