User's Manual

7. Operation Procedure

A. TRANSMITTER OPERATION

a. Reset the emergency stop button located on the top left hand side of the transmitter handset by

rotating it either clockwise or counter clockwise, the red button will pop up.

b. Turn on the transmitter power by inserting the black-colored key onto the power key slot located on

the top right hand side of the transmitter handset and rotate it clockwise to “On” position.

c. After turning on the transmitter power, the green light on the transmitter status LED will light up for

up to 2 seconds, which means that the system is ok. If the green light did not appear on the Status

LED, then please refer to “Status Light Indicators & Warnings” on page 24.

d. If there are no signs of any system irregularities, then rotate the power key further clockwise to

“Start” position for up to 1 second, this will activate the receiver MAIN. The power key will

retract back to “On” position automatically after release.

e. Now press any push button on the transmitter handset to operate the crane or equipment.

f. In case of an emergency press down the red emergency stop button will immediately disconnect the

receiver mainline. The transmitter status LED will blink red (refer to page 24). To reset the

emergency stop button just rotate the red button either direction, it will pop up. Then rotate the

power key to “start” to resume operation (MAIN activated).

g. To turn off the transmitter handset, just rotate the power key to “Off” position, it will disconnect the

transmitter power and the receiver MAIN altogether.

h. Change batteries simply by unscrew the battery cover located on the back side of the transmitter

handset.