User's Manual

2. Step-By-Step Installation

1. For better reception, the location of the receiver should be visible to the operator at all time.

2. The location selected should not be exposed to high levels of electric noise. Mounting the

receiver next to an unshielded variable frequency drive may cause minor interference.

Always locate the receiver as far away from variable frequency drive as possible .

3. Ensure the selected location has adequate space to accommodate the receiver.

4. Make sure the receiver is in upright position.

5. Drill two holes (10mm in diameter) on the control panel or location where the receiver is to be

installed (Refer to Fig. 13 on page 21).

6. Make sure the bolts are tightened after installation.

7. For system wiring please refer to Fig.12 on page 20.

3. System Testing

1. Turn on the power source to the receiver and test the MAIN relay output by pressing the red

emergency stop button and observe that it properly opens and closes the main line

disconnect contactor.

2. Test the operation of each function to ensure it corresponds to the transmitter direction labels

or the pendent it is replacing.

3. Test the limit switches to see if they are working properly.

4. If your new remote control is replacing an existing pendant, make sure it is completely

disconnected and placed in a safe location to prevent unwanted control command.