User's Manual

15
10. Magnet ON/OFF Function
The user can set the two adjacent push buttons to control a magnet. To activate the magnet
just press the button with the Magnet symbol. To deactivate the magnet, for safety purpose,
you must press and hold the button with the Magnet symbol and press the OFF button.
Pressing the OFF button alone can and will not deactivate the magnet.
11. Brake Function
When the transmitter push button is released from 2
nd
speed down to 1
st
speed, electronically,
both 1
st
and 2
nd
speed output relays will be deactivated for up to 1.0 second and then with 1
st
speed output relay reactivated thereafter.
12. External Warning Function
The user can install an external warning device (rotating lights, horn, etc…) to a special
“function relay” located inside the receiver. The user can choose which push button pairs or
crane motion he wants to have external warnings when push button is pressed. If the
programmed push button is pressed it will activate the function relay thus activating the
external warning device.
13. Momentary Contact
When push button is released the output relay corresponds to that push button will be
deactivated.
14. Toggled (Latching) Contact
When push button is released the output relay corresponds to that push button will remained
activated until next time the user presses the same push button again.
15. 3
rd
Speed Function
This function allows the crane to travel additional step beyond 2
nd
speed. At second speed,
pressing the 3
rd
speed push button will toggle between 2
nd
and 3
rd
speed.
16. Auxiliary Stop Function
The special stop function acts as a 2
nd
emergency stop button. The receiver MAIN will also
be deactivated when this Stop push button is pressed.