User's Manual

FLEX MINI System Instruction Manual
January 2014
7 of 16
PB3
+
ON
1
2. FUNCTION SETTINGS
2.1 TRANSMITTER
2.1.1 Channel Setting
Set transmitter channel by moving the function dipswitch located inside the battery
compartment to “on” position. Reinsert the two batteries and press any button to power up the
transmitter. At this point the Status LED will display a series of red, green and orange blinks
showing the current software version. Then press and hold PB3 for up to 1 second to go into
the transmitter channel setting mode. At this point the Status LED will display a series of green
and red blinks showing the current system channel. A green blink represents the tens (+10)
and a red blink represents the units (+1). For example, one (1) green blink followed by five (5)
red blinks is channel 15.
Now select new channel by pressing PB1 and PB2 on the transmitter. Press PB1 to
increment the units (+1) and PB2 to increment the tens (+10). For example, press PB2 two
times and then PB1 four times is channel 24. When finished the transmitter Status LED will
display the newly selected channel. Then press and hold PB3 again to transmit the newly
selected channel to the receiver (receiver must be powered on). Let go PB3 only when
receiver Status LED displays fast green blinks (transfer complete); this process should only
take 1~2 seconds. Exit transmitter channel setting mode by press and hold both PB1 and
PB2 at the same time for up to 1 second (Status LED returns to software version). Then
take out the batteries and move the function dipswitch back to “off” position.
Note: When selecting a new channel make sure each button press do not exceed 3 seconds.
Important Note:
When you are changing the transmitter channel you must also change the receiver channel
at the same time, prior to exiting the channel setting mode (see instruction above). If you
exit the channel setting mode without pressing PB3 to transfer the newly selected channel to
the receiver then you would have to change the transmitter channel back to its previous setting
(same channel as the receiver) and then redo the channel setting process again.