User's Manual

FLEX MINI System Instruction Manual
January 2014
9 of 16
PB3PB4
+
ON
1
PB3 PB4
PB4
2.1.3 Remote Pairing
Set remote pairing function by moving the function dipswitch located inside the battery compartment
to “on” position. Reinsert the two batteries and press any button to power up the transmitter. Then
press and hold PB3 and PB4 at the same time for up to 1 second to go into
the remote pairing setting mode (Status LED off).
TX to TX Pairing:
→
Sending data – original transmitter Receiving data – new transmitter
(Press and hold PB3) (Press and hold PB4)
Sending data (original transmitter) by press and hold PB3 and receiving data (new transmitter)
by press and hold PB4 at the same time. When the Status LED on the receiving data end (new
transmitter) turns to constant green while pressing down PB4 the pairing is completed. Exit
remote pairing mode by press and hold both PB1 and PB2 at the same time for up to 1 second
(Status LED turns to software version). Then take out the batteries and move the function
dipswitch on both transmitters back to “off” position.
RX to TX Pairing:
→
Sending data - receiver Receiving data – new transmitter
(Press and hold PB1) (Press and hold PB4)
Sending data (receiver) by press and hold PB1 located on the decoder board (see above) and
receiving data (new transmitter) by press and hold PB4 at the same time. When the Status LED
on the receiving data end (new transmitter) turns to constant green while pressing down PB4 the
pairing is completed. Exit remote pairing mode by press and hold both PB1 and PB2 on the new
transmitter for up to 1 second (Status LED turns to software version). Then take out the batteries
and move the function dipswitch back to “off” position.