User's Manual

FLEX MINI System Instruction Manual
January 2014
8 of 16
PB4
+
ON
1
PB3PB4
PB5PB6
PB8 PB7
PB2
Ty p e 1
PB1
PB3PB4
PB5PB6
PB8 PB7
PB2
ON
OFF
Typ e 2
PB3PB4
PB5PB6
PB8 PB7
START
Typ e 3
STOP
2.1.2 Keypad Type Setting
Set transmitter keypad type by moving the function dipswitch located inside the battery
compartment to “on” position. Reinsert the two batteries and press any button to power up the
transmitter. At this point the Status LED will display a series of red, green and orange blinks
showing the current software version. Then press and hold PB4 for up to 1 second to go into
the keypad type setting mode. At this point the Status LED will blink red showing the current
keypad type. A green blink represents the tens (+10) and a red blink represents the units (+1).
For example, two (2) red blinks is keypad type #2.
Now select new keypad type by pressing PB1 and PB2 on the transmitter. Press PB1 to
increment the units (+1) and PB2 to increment the tens (+10). For example, press PB1 two
times for keypad type #2 and three times for keypad type #3. When finished the Status
LED will display the newly selected keypad type. Exit keypad type setting mode by press
and hold both PB1 and PB2 at the same time for up to 1 second (Status LED returns to
software version). Then take out the batteries and move the function dipswitch back to “off”
position.
Note: When selecting a new keypad type make sure each button press do not exceed 3 seconds.