User's Manual

Page 27

b. Non-Interlocked Functions

Contrary to interlocked settings, non-interlocked settings allow the two adjacent push buttons be

used simultaneously at the same time. Non-interlocked settings are usually applied to crane’s

auxiliary functions such as lights, horn, 3

speed, auxiliary stop and Pitch & Catch. Each

dip-switch on the decoder module corresponds to one (1) motion or two (2) adjacent push

buttons (left & right push buttons).

Function

Code

Dip

Position

Setting

Dip Position Setting

#2 ~ #4 (left button)

#5 ~ #7 (right button)

Function Description

A 1 000

Normal (momentary) contact

B 1 001

Toggled (latching) contact

C 1 010

Acceleration (3

speed)

D 1 100

Normal + Start function. For added safety,

you must first rotate and hold the power key

switch at “START” position and then press

the intended push button at the same

time to activate the output relay.

E 1 110

Pitch & Catch

F 1 111

Auxiliary Stop

Example #1: Left button (set to function code A) / right button (set to function code A) → 1 000 000

Example #2: Left button (set to function code B) / right button (set to function code B) → 1 001 001

Example #3: Left button (set to function code A) / right button (set to function code C) → 1 000 010

Example #4: Left button (set to function code F) / right button (set to function code A) → 1 111 000

! When set to Pitch & Catch function make sure the 2

transmitter is set to the next upper channel. For example, if the

system is preset at Ch.01 then the 2

transmitter should be set to Ch.02. Furthermore, you must also set the dip-switch on

the receiving module (position #7 & #8) to “10” position (2-channel scanning), please refer to page 25.

!! When set to “Auxiliary Stop” do make sure that JP3 is inserted (refer to jumper settings next page).