User's Manual

Flex ECO 4S/4X/8S/8X/12S/12X Instruction Manual
April 2015
Page 21 of 36
41 32 65 87
4132 65 87
4231 7856
41 2 3 65 78
4.2.2.11 Auxiliary STOP Function
The auxiliary STOP function acts as a 2
nd
emergency stop
button. When pressed, the receiver MAIN relays are
deactivated (refer to section 4.2.3.2 on how to set to this
function). When set to this function the Start Function on
section 4.1.4 must set to “START” button reactivation.
4.2.2.12 Pitch & Catch Function
This function allows two operators controlling a crane, hoist or equipment from
opposite ends of the facility. When set to “Pitch & Catch” make sure the 2
nd
transmitter is set to the next upper channel (channel X+1). For example, if the
original (1
st
) transmitter and receiver are set to channel 01 then the newly added 2
nd
transmitter must set to channel 02 (all with same serial number). Furthermore, the
Channel dipswitch position #7 and #8 on the RF/decoding board in the receiver must
set to “10” for 2-channel scanning (scans channel 01 and 02). Refer to section
4.2.2.13 and 4.2.3.2 on how to set to this function.
4.2.2.13 Receiver Channel Scanning Function
(1) → “00” manufacture preset (channel X)
(2) → “01” scans 2 channels (channel X and channel X+1)
(3) → “10” scans 3 channels (channel X… channel X+2)
(4) → “11” scans 4 channels (channel X… channel X+3)
* Channel X → channel set on the Channel dipswitch
Example: If the first 6 dipswitch positions are set to channel 01 (000001), when set to 2-channel
scanning (type-2 above) the receiver will only scan channel 01 and 02.