User's Manual

Flex ECO 4S/4X/8S/8X/12S/12X Instruction Manual
April 2015
Page 15 of 36
4.1.4 Start Function Settings
When transmitter goes into sleep mode (MAIN relays deactivated) press the START button or
any pushbutton to wake up the system (MAIN relays reactivated).
1) After entering the Function Setting Mode (refer to
section 4.1.1 Enter Function Setting Mode).
2) Press PB4 for up to 1 second (Status LED orange).
3) Release PB4 (Status LED with 1 or 2 red blinks).
4) Entered Start Function Mode.
5) Press PB1 to toggle between “START” button and
“ANY” pushbutton reactivation.
* START button reactivation → 2 red blinks
* ANY pushbutton reactivation → 1 red blink.
6) Exit Function Setting Mode by pressing down the
STOP button and set the dip position #10 back to “0” or OFF position.
7) Reset the STOP button and then press the START button to resume operation.
Note : When selecting a new setting make sure each button press do not exceed 3 seconds.
4.1.5 Inactivity Timer Settings
Set how long the system enters the sleep mode after
transmitter inactivity (pushbutton not pressed).
1) Press down the STOP button.
2) Open the battery cover.
3) Set dip position #9 to “0” or OFF for 1 minute.
4) Set dip position #9 to “1” or ON for 3 minutes.
5) Please contact ARC representative if your
application requires a different timer value other
than 1 and 3 minutes.
4.1.6 Infrared Programming
Functions not listed in this manual can be programmed via
the infrared programmer unit, such as the system serial
number, system channel, transmitter output power,
Function output relay settings, etc… Please contact ARC
representative in your country for more details.