Owner Manual

CLEANING AND MAINTENANCE
11
The dust collector cell needs cleaning when:
The dust collector cell may not require cleaning if “arcing” occurs. Arcing is a sharp snapping sound that
occurs when large particles are collected in the dust collector cell or the appliance used in over damp
rooms.
Cleaning the Dust Collector Cell
Remove the front cover, dust
collector cell and pre-filter
Soak the dust collector cell before
cleaning
1
2
·Please refer to page 9 for detailed instructions
on the removal of the dust collector cell and
pre-filter.
Caution
① Use mild detergent
Place the dust collector cell in sink, bathtub or
other location where cleaner can cover every
surface.
② Use warm water(below 40℃) only!
Tough residue such as tar from tobacco
smoke does not wash away easily:
“CLEAN CELL” indicator appears or blinks on the screen
The dust collector cell is too dirty or continuous arcing occurs
Reset the "REPLACE FILTER” indicator
Please refer to instructions on page 7 for resetting after
replacement, otherwise the indicator will remain on screen.