Owner manual

Figure 2
Typical TE/1C40 SPD Installation
Page 3
Flush Mount Installation Instructions
1. Select the location where the SPD and Flush Mount Kit (FMKITC) will be mounted. Aesthetics may have to be
sacricedinordertoachievemaximumsurgeprotection.
2. Place the Flush Mount Kit plate where it will be mounted and trace the center hole and mounting holes. Cut this
shape into the mounting surface and mount the FMKITC panel to the mounting surface (see Figure 2).
3. BE CAREFUL TO NOT DROP THE SPD INTO THE WALL.
4. Install the SPD to the back side of the Flush Mount Kit plate using the four 8/32 x 5/8” Thread Cutting Screws
provided with the FMKITC kit.
5. Proceed with #6 on previous page.
Side View
Top View
Thread Cutting Screws
SPD
*Drawing reects additional hardware not provided
Note: Panelboard Cover Trim drawing based 2”. Adjust Male Conduit tting length appropriately.
*
Insertushmountscrewthrough
hole in each corner or punch a
small starting hole in center of
each translucent window (located
in all 4 corners of the label).