Installation Manual

INTRODUCTION
8
The technical materials and information contained in this document are strictly confidential and the exclusive property of Advanced Microwave Engineering s.r.l.
These materials and information are intended solely for the purpose designated and may not be used otherwise.
It is not permitted to disclose or reproduce them in whole or in part without express written permission.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
3.3.1 Statements for PLXSAFEMOVESENS4 and PLXSAFEMOVESEN4M.
This product complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment. The antenna
should be installed and operated with minimum distance of 20cm between the radiator and your body.
4 INTRODUCTION
4.1 INTENDED USE
The EGOpro Safe MOVE 4.0 System is a safety supporting system that is used for detecting the presence of pedestrian
workers and vehicles equipped with suitable devices. When either are detected, sound and visual signals are generated,
to which the I/O that are present in the system can be associated.
4.2 SYMBOLS
Symbol Description
DC or AC voltage
DC voltage
Symbol no. 5031 of IEC 60417 is used to indicate, on the identification plate, that the
equipment may only be used with direct current.