Installation Manual

INSTALLATION ON THE VEHICLE
18
The technical materials and information contained in this document are strictly confidential and the exclusive property of Advanced Microwave Engineering s.r.l.
These materials and information are intended solely for the purpose designated and may not be used otherwise.
It is not permitted to disclose or reproduce them in whole or in part without express written permission.
NOTE: the mechanical joint supplied can be used to obtain the desired inclination.
Front sensors must have a slight orientation towards the outside. For example, for a counterbalanced vehicle, they must
be positioned outside the moulding of the fork/gripper holder mounting, and they must have an orientation angle towards
the outside of around 20°.
Be careful not to place the sensors behind obstacles such as the turret of the forks or the vehicle chassis.
For the best operation of the sensors, they must be installed in areas that are as free as possible.
8.2.4 Positioning the HUB
The HUB can be positioned at any point inside or outside the driver’s cabin, even in a hidden area, but the external RF
antenna (whip aerial antenna), connected to the HUB by means of a 1.5m-long cable, must be outside the driver’s cabin
in vertical position.
To position the external antenna, also refer to the HUB connections (see section
8.3.4
).
The position of the HUB must not obstruct the driver’s and the vehicle operability, and it should be handy to
connect the Sensors and the CPU.