Installation Manual

TURNING-ON AND CONFIGURATION
41
The technical materials and information contained in this document are strictly confidential and the exclusive property of Advanced Microwave Engineering s.r.l.
These materials and information are intended solely for the purpose designated and may not be used otherwise.
It is not permitted to disclose or reproduce them in whole or in part without express written permission.
9.2.7 SEARCHING SENSORS WITHOUT ID
A fixed position can be assigned to the sensors without making the ID search. In this case, place the selector present on
each sensor in the desired position. For example, for the basic kit:
 FRONT LEFT: 2
 FRONT RIGHT: 8
 REAR: 5
The selector present on the HUB must be set to 0.
In this case, the SEARCH SENSORS BY ID procedure (STEP 5) must not be followed.
9.3 TEST
Once the sensors have been configured and saved to the system, make a test to check that it works correctly.
In general, the system is working correctly if the central part of the monitor is no longer red.
9.3.1 SENSOR CHECK
All sensors are in good working order if they are all green.
The Warning detection system (indicated with SR) is in good working order if the indicator on the top left corner on the
monitor is green.
If the Vehicle
-
Vehicle module is active and the
white sectors are displayed indicating the presence of a vehicle
but there are no other vehicles with sensors installed nearby:
 Try restarting the system
 Disconnect and connect again the power supply connector on the HUB
 Repeat the sensors search procedure
Sensor 2
Sensor 5
Sensor 8
Warning
Detection