User guide

Copyright 2004 Advanced Merchant Solutions, Inc. Page 7
Resetting the printer
Your Pocket Merchant and reader has a CPU and memory, just like your PDA. If
the error light stays on, or the printer will not respond to a print command or card
swipe, the unit can be reset by pressing the button recessed in the underside of
the printer.
Figure 4 – Reset button
Loading Paper
Your Pocket Merchant printer has the easiest paper loading system available.
Simply open the paper door by squeezing the paper door release tabs. Unroll
about 2 or 3 inches of paper, and place the roll in the printer as shown below.
Then, simply close the door on the paper and tear off the excess. When the
printer runs out of paper, the red “ERROR” LED will illuminate. The last few feet
of paper on each roll has a pink edge to let you know that you are running low.
Figure 5 – Loading paper