User guide

Printer output is the same in double-strike mode and in emphasized mode.

Double-strike mode can not be used for the bit image.downloaded bit image, and

bar code.

[Default ] n =0

[Reference ]ESC E

ESC J n

Print and feed paper

Hex 1B 4A n

Decimal 27 74 n

[Range ] 0 ≤≤n ≤255

[Description ]

Prints the data in the print buffer and feed the paper [n × vertical or horizontal

motion unit ] inches.

[Notes ]

After printing is completed, this command sets the print starting position to the

beginning of the line. The paper feed amount set by this command does not

affect the values set by ESC 2 or ESC 3. The horizontal and vertical motion unit

are specified by GS P. The GS P command can change the vertical (and

horizontal)motion unit. However, the value cannot be less than the minimum

vertical movement amount, and it must be in even units of the

minimum vertical movement amount. In standard mode, the printer uses the

vertical motion unit (y). When this command is used in page mode, the

command functions as follows, depending on the starting position of the printable

area. ① When the starting position is set to the upper left or lower right of the

printable area using ESC T, the vertical motion unit (y)is used.② When the

starting position is set to the upper right or lower left of the printable area using

ESC T, the horizontal motion unit (x)is used. The maximum paper feed amount

is 40 inches. Even if a paper feed amount of more than 40 inches is set, the

printer feeds the paper only 40 inches.

[Reference ] GS P

ESC a n

Select justification

Hex 1B 61 n

Decimal 27 97 n

[Range ] 0 ≤≤n ≤2,48 ≤n ≤50

[Description ]

Aligns all the data in one line to the specified position.n selects the type of

justification as follows :

[Notes ]

The command is enabled only when input at the beginning of the line. If this

command is input in page mode, the printer performs only internal flag operation.