User guide

ESC 3 n

Select line spacing

Hex 1B 33 n

Decimal 27 51 n

[Range ] 0 ≤≤n ≤255

[Description ] Sets the line spacing to [n × vertical or horizontal motion unit ]

inches.

[Notes ]

The line spacing can be set independently in standard mode and in page mode.

The horizontal and vertical motion unit are specified by GS P. Changing the

horizontal or vertical

motion unit does not affect the current line spacing. The GS P command can

change the horizontal (and vertical)motion unit. However, the value cannot be

less than the minimum vertical movement amount, and it must be in even units of

the minimum vertical movement amount. In standard mode, the vertical motion

unit (y) is used. In page mode, this command functions as follows, depending on

the starting position of the printable area: ① When the starting position is set to

the upper left or lower right of the printable area using ESC T, the vertical motion

unit (y)is used. ② When the starting position is set to the upper right or lower left

of the printable area using ESC T, the horizontal motion unit (x) is used. . The

maximum line spacing is 40 inches. When the setting value exceeds the

maximum, it is converted to the maximum automatically.

[Default ] n =60 (1 /6 inch)

[Reference ] ESC 2,,GS P

ESC @

Initialize printer

Hex 1B 40

Decimal 27 64

[Description ]

Clears the data in the print buffer and resets the printer mode to the mode that

was in effect when the power was turned on.

[Notes ]

The data in the receive buffer is not cleared.

ESC D [n ] k NUL

Set horizontal tab positions

Hex 1B 44 [n ]k 00

Decimal 27 68 [n ]k 0

[Range ] 1 ≤≤n ≤0 ≤k ≤32

[Description ] Set horizontal tab positions..

n specifies the column number for setting a horizontal tab position from the

beginning of the line. k indicates the total number of horizontal tab positions to

be set.