User guide

PAY@PC • User Guide and Tutorial • 2.00.0629.2009 page 51
Trouble-Shooting
Pairing the Pocket Spectrum with a Bluetooth Device
To correctly pair the Pocket Spectrum, follow these steps:
1. Full charge the Pocket Spectrum.
2. Make sure there is paper in the Pocket Spectrum.
3. If you are using a laptop, make sure it is plugged in or fully charged.
4. Reset the Pocket Spectrum by:
a. Turning on the Pocket Spectrum.
b. Turning over the Pocket Spectrum and press the reset button using a thin paperclip or pin –
the small hole next to the battery compartment. This will turn off the Spectrum.
c. Pressing and Holding the On button for 3 seconds.
Once the diagnostic sheet prints out, the spectrum is ready for pairing
5. Start the pairing process by following the instructions that came with your computer or Bluetooth
adaptor. Note: Make sure to search for all devices.
6. Select the Pocket Spectrum from the list of devices.
The device name (Bluetooth ID) should start with MSP.
The actually name will be printed on your diagnostic sheet next to B/T ID.
7. Enter the Passkey 1000
8. Enter the service and assign a COM Port for the outgoing connection.
If an outgoing COM Port is already assigned, use that COM Port in PAY@PC.
If the Bluetooth Printer is not connected, then PAY@PC will not display the COM Port in the Device
Printer or Card Reader Settings.