User manual

Performer | 7
3
Setup & Multi Mode DVD Burning
This section will explain how to connect/ record/ burn a DVD
with your MediaPOINTE Performer in Multi mode utilizing the
KeyCard system. For more information about where and when
to use the MediaPOINTE KeyCard system, refer to Chapter 6.
1. Connecting
• S-video is the default video input on the
MediaPOINTE Performer. Connect the S-video output of
the optional camera to this input jack.
o If you need to use the composite input, please refer
to the manual or call tech support.
•ConnecttwoRCAcables(L&Raudio)fromthe
outputmixer/sourcetotheinput(L&Raudio)ofthe
MediaPOINTE Performer.
•Withtheappropriatecable(composite/s-video)
connect the output of the MediaPOINTE Performer to a
videomonitorasacondencemonitor.
o On power up, the MediaPOINTE Performer senses
what output is connected and will disable the one not
being used; so it is important to have the video output
connected to the display on power up.
o**IMPORTANT**Ifacondence
monitor is not being used, please
connectthegold75ohmterminator
(supplied)tothecompositeoutofthe
MediaPOINTE Performer
• Make sure that the power supply switch on the back
of the MediaPOINTE Performer is switched off. Connect
thesuppliedIECpowercabletotheA/Cjackofthe
MediaPOINTE Performer; connect the other end of this
cabletoapoweredelectricaloutlet(110/240V~50/
60Hz).
• Switch the power supply switch on the back of the
MediaPOINTE Performer to the ON position.
2. Switching between single and
Multi Mode
• Turn the MediaPOINTE Performer on by pushing the
powerbuttononthefrontpanel.Power-uptakes50~60
seconds to complete.
oBoot-upisindicatedbyanorangeLED
o When the MediaPOINTE Performer is ready, the blue
LEDonthefrontpanelwillbeonsolid,andyouwillsee
your video source on the monitor.
•WiththeKeyCardpurchase,youreceivedablackand
silverfoldableUSBstickwiththeMediaPOINTElogo
imprintedonit.ThisUSBstickisusedtochangethe
modeoftheMediaPOINTEPerformercalledKar.switch.
Please follow steps below to switch modes.
***IMPORTANT***pleasemakesurethe
MediaPOINTE Performer has had all of
its recordings canceled before you
switch Modes. i.e. press the right
arrow button on the front panel
(>>).Themessage“Burning
cancelled:/DVD_xxxxx”willbe
displayed for the last recording.
1.WiththeMediaPOINTEPerformerpoweredupandin
anidlestate,inserttheKar.switchUSBintothefront
USBportoftheMediaPOINTEPerformer
2.TheGreenLEDontheKar.switchUSBwillilluminate
and start blinking, followed by a “swoosh” sound.
3.“Executing/amd/Kar.switch”willbedisplayedand
the MediaPOINTE Performer will reboot. Please leave
theKar.switchUSBintheMediaPOINTEPerformeruntil
the MediaPOINTE Performer has rebooted. This process
takes80~90secondstocomplete.
4. Once the MediaPOINTE Performer has rebooted
pleaseremovetheKar.switchUSB.