User manual

Performer | 5
2
Setup & Single Mode DVD Burning
Single Mode DVD Burning is the Default
Setting for theMediaPOINTE Performer.
This section will explain how to connect/ record/ burn a DVD
with your MediaPOINTE Performer in single mode.
**IMPORTANT**IfyouhavepurchasedtheKeyCard
system, please refer Chapter 3.
1. Connecting
• S-video is the default video input on the MediaPOINTE
Performer. Connect the S-video output of the optional
camera to this input jack.
o If you need to use the composite input, please refer
to the manual or call tech support.
•ConnecttwoRCAcables(L&Raudio)fromthe
outputmixer/sourcetotheinput(L&Raudio)ofthe
MediaPOINTE Performer.
•Withtheappropriatecable(composite/s-video)
connect the output of the MediaPOINTE Performer to a
videomonitorasacondencemonitor.
o On power up, the MediaPOINTE Performer senses
what output is connected and will disable the one not
being used; so it is important to have the video output
connected to the display on power up.
o**IMPORTANT**Ifacondencemonitor
is not being used, please connect the
gold75ohmterminator(supplied)tothe
composite out of the MediaPOINTE
Performer
• Make sure that the power supply switch on the back
of the MediaPOINTE Performer is switched off. Connect
thesuppliedIECpowercabletotheA/Cjackofthe
MediaPOINTE Performer; connect the other end of this
cabletoapoweredelectricaloutlet(110/240V~50/
60Hz).
• Switch the power supply switch on the back of the
MediaPOINTE Performer to the ON position.
2. Using the MediaPOINTE
Performer (Singlemodeisthedefaultsetting)
• Turn the MediaPOINTE Performer on by pushing the
power button on the front panel. Power-up is between
50~60seconds
oBoot-upisindicatedbyanorangeLED
o When the MediaPOINTE Performer is ready, the blue
LEDonthefrontpanelwillbeonsolid,andyouwillsee
your video source on the monitor.
• Adjust the camera as desired.
•InsertablankDVD-RorDVD+Rdiscintotheoptical
drive.Discacceptanceisbetween20~25secondsandis
indicated by a “swoosh” sound
o A disc can be inserted any time before or after a
recording has been started.
o If the disc is not blank or is damaged, the
MediaPOINTE Performer will eject the disc.
•PushtheREConthefrontpanelmembraneswitch.
o You will see a record icon and the record message
“Nowrecording:/DVD_xxxxx”onthemonitor.Thered
LEDonthefrontpanelwillalsobeilluminated.
•Tostoprecordingpushthedownarrow/squareicon
key on the front membrane switch.
o Once you’ve stopped the recording, the message