User Manual

2SetUpandInflation
2.1SetUp
1. PulltheHula™11outofitsbagandun‐foldit.
2. LocatetheFinholdersonthebottomsideoftheboardatthetailend.TakeeachFinandhookthemintoplace
makingsurethatthelongerportionisgoingtowardstheendoftheboard.YouwillneedtobringthetwoFin
holdersclosetogetherinordertoget eachFinhookedintoplace.Seeimages1and2.
3. OncetheFinsareinplace,turntheboardoversothatthevalveatthefrontoftheboardisfacingup.

Image1    Image2
2.2Inflation
PumpSet‐up:
YourSingleActionHandPumpcomeswitharemovablepressuregaugethatneedstobeattachedtothepumpbefore
use.Note:Whenthepumpisstored,itisrecommendedthatyoudetachthepumpgaugeandstoreitsomewherethat
thegaugewillbeprotectedfrombeingcrushedordamaged.
1. AttachthegaugehousingtotheT‐HandleofthepumpintheInflateposition
2. Attachthepumphosetothegaugehousing.
Inflation
1. Removethecapfromthevalveandchecktoseeifthesteminthecenterofthevalveisup(stickingupoutof
thevalve)ordown(evenwiththeinnerrimofthevalve).Thestemofthisvalvemustbeintheup(inflate)
positiontoinflatetheSUP.Ifthevalveisnotintheinflateposition,useyourfingertopushinandturnthestem
counterclockwiseaquarterturnanditwillspringupintotheinflateposition.SEEIMAGES3AND4.
2. SeatthevalveadaptorincludedwiththeSUPPumpontothevalveturningclockwisetolocktheadaptorinto
place.
3. InflatetheSUPto11.0psi.Makesurethatyoudonotexceed12.0psioryouwilldamagetheSUP.
4. OnceyouaredoneinflatingtheSUP,disconnectthevalveadaptorbyturningcounterclockwiseandclosethe
valveusingtheattachedva lvecap.Makesureyoulockthevalvecapintoplacebyturningclockwise.