Owner's manual

TM
10
Deate
Inate
Figure 3. Inate/Deate Boston Valve
To begin inating your kayak, you will need a Bellows Foot Pump or a Double Action Hand
Pump. Never use compressors, CO2 or compressed air as they may damage your kayak.
Diagram of Ination Chambers
3.3 Inating
IMPORTANT: Before inating, check to be sure that the canoe is completely assembled. Inate
your canoe in the following order. Failure to follow these instructions may cause damage to
your canoe. Do not over inate.
1. Locate chamber 1 (oor). Aach pump hose to valve and Inate until rm (1.0 psi ONLY).
Position in the center of the canoe (CAUTION: Do not over inate).
2. Proceed to chamber 2 and 3. (Bow and Stern Bags) Inate until rm (1.5 psi ONLY).
3. Locate chambers 4 and 5 right and le “side tubes”. Check to be sure spring valve is in the
inate position (See Figure 1). Inate chambers until rm (1.5 psi ONLY). Do not over inate.
4. Locate Chambers 6 and 7 (seat cushions). Inate Chambers to desired rmness (Max 1.5 psi).