Specifications

problem Isolation
8.4 Look At The Symptoms (continued)
Table 8-1. Problem Symptoms And Solutions (continued)
D.
When trying
to
copy a
tloppy diskette
to
the hard
disk drive
tixed disk
error
message
is
displayed.
E. Serial printer
won't accept
data and give
a printout.
F. CRT will not
display any
data. The
screen is
blank but the
SUPER STAR
system is
running.
1 •
The
hard disk
drive
tixed disk
was never
tormatted.
2.
You
are not
using the
proper
"copy"
command
tor the
media
you are
trying
to
copy.
3 •
'l'he directory
was never
initialized.
1. The intertace
cable is plugged
into the wrong
serial intertace
connector on the
back panel.
2. Your serial
printer intertace
cable may not
provide all
Signals required
by the printer.
1. A tuse has blown
on the display
terminal.
8-4
1 .
Read
Section
5,
Copying
The System Disk
(TurboDOS
CP/M 2.2
or
CP/M
3.0)
2.
Reter to
the Operating
System Reterence Manual
tor
the media
you are
USing.
Look
at
"copy"
command.
3.
TYI--e
"ERA A: II
(CP/lil)
Type
"ERASEDIR
A: II
(TurboDOS)
1. Reter to Figure 2-3
tor location ot intertace
connectors. Check your
system c6ntiguration
against the intertace
cable requirements. As
an example, is the serial
printer being driven by
the SUPER QUAD, SIX or
SLAVE board?
2. Read Section 3 ot this
manual and the
installation section ot
the manutacture's manual.
1. Check the display
terminal's manutacturer's
manual tor location and
size ot the tuse.