Specifications

Installation and Intialization
5.4 Copying The System Disk (CP/M 3.0) (continued)
11. When the system has completed the tormatting ot the disk,
enter the LDRGEN cgmmand. This command should only be used it
you intend to boot trom the tixed drive when powering up the
system. It you do not want the system to boot trom the tixed
disk then skip to Step 13. The LDRGEN command puts a track zero
loader onto the hard disk you are creating:
A)LDRGEN T30DMA55.LDR[RETURNl
Physical drive no. ot loader destination (0-3):0
Write loader to cartridge or tixed [C or Fl:F
12. Press RETURN. The system copies the loader trom the
cartridge drive to the tixed hard disk.
13. Copy the tile CPM.SYS trom the cartridge to the tixed disk
as to1lows:
A)PIP B:CPM.SYS=:CPMH.SYS[RETURNl
14. The tile CPM.SYS is copied to the tixed hard disk.
15. Next, set the tile CPM.SYS to read-only status:
A)STAT B:CPM.SYS $R/O[RETURN]
16. Once the CPM.SYS tile is set to read-only, copy the rest ot
the system disk to the tixed disk.
A)PIP B:A:*.*[v] [RETURN]
[v] - alows veritication
17. When this is complete compare the two disks, master and new
copy using the directory command:
A)DIR A: [RETURN]
Directory A is displayed by the system
A)DIR B:[RETURN]
Directory B is displayed by the system
This completes the copy procedure. Power down the drive and
remove your cartridge with the operating system trom the drive.
Store this in a sate location.
5-12