Specifications

Installation and Initialization
5.1 Installation Procedure (continued)
6. Turn the power switch to the OFF position on
SUPER STAR it it is not already in that position.
power cord to the rear ot the SUPER STAR system.
power cord to the rear ot the console and plug it
source, but do not power up the system console.
NOTE
the console and
Connect the AC
Connect the AC
into a power
The power switch on the SUPER STAR system is in
the OFF position it the power switch light is not
lit and ON when the the light in the power switch
is lit.
7. Press the power switch ot the SUPER STAR into - the ON
position. The LED on the switch should light. The LED on the
tloppy disk drive should also be lit. This indicates that the
SUPER STAR is trying to access data trom the tloppy disk drive.
8. Open the cartridge drive door by pressing the disk release
button (see Figure 2-1) and gently lowering the cartridge drive
door.
9. Insert a cartridge, either blank (it using CP/M) or an
operating system (it using TurboDOS or CP/M 3.0) into the drive.
Make sure that the red write protect tab is in the lower
right-hand corner tacing you. The bottom ot the cartridge is the
side which ahs the circular metal plate, this side must be
tacing down when the cartridge is inserted into the drive. See
Appendix A it you are not tamiliar with diskettes and cartridge
disks. Gently slide the cartridge into the drive, pressing on
the lett tront side ot the cartridge disk, until it is properly
seated.
10: Close the drive door. The cartridge should drop into
position as the drive door is closed.
11. Set the Write Protect Switch to the ON position. The switch
is in the "ON" position when the right-hand side ot the switch is
t1ush with the tront ot the disk drive. This protects the data
on the cartridge trom being damaged or being written on.
12. Press the RUN button to the ON position. The switch is in
the "ON" position when the right-hand side ot the switch is tlush
with the tront ot the drive. The green run light should begin to
blink as the drive comes up to operating speed. When the drive
is up to operating speed, the green light stops blinking and
remains lit and the red light or "ready" light comes on to
indicate that the drive is ready.
5-2