Specifications

SECTION 5
INSTALLATION AND INITIALIZATION
This section explains the procedures necessary to setup and
initialize the SUPER STAR system. There are operating system
backup procedures given tor both CP/M and TurboDOS operating
systems.
5.1 Installation Procedure
1. Betore removing the SUPER STAR maintrame trom its shipping
container, inspect the outside ot the container. It any damage
is tound, notity the shipping company and Advanced Digital
immediately.
2. Caretully remove the SUPER STAR trom the shipping container.
Inspect the exterior ot the maintrame tor any damage. It any
damage is tound, notity the shipping company and Advanced Digital
immediately.
3. place the SUPER STAR maintrame on a level counter or desk
top.
4. Open the SUPER STAR maintrame by removing the cover and check
the seating ot the boards and cable connections.
5. Connect the master console to the proper rear panel 1/0
connector marked "1" at the rear ot the SUPER STAR system.
CAUTION
Check the tuse package at the rear ot the SUPER STAR
system. You should be able to read the lettering on
the small circuit board which is inserted under the
tuse. It the number which you can read rightside up
is not the proper voltage STOP STOP STOP!!! Turn to
Section 4.4, Changing AC Voltage and tollowing the
procedure listed there.
5-1