System information

59
2. In the “Sequence” setup menu, first
input the sequence number (1 – 16).
Each sequence is made up of a series of
preset positions. Each “sequence”
includes the preset number, dwell time
(how long it will stay in each position)
and dwell speed (how long it takes to
move to the next sequence position).
Press the “Add” button to add a preset
point.
3. Press “Confirm” button to save the
cruise point into the sequence.
4. After you finish the setup the sequence numbers, press “StartSeq” to check the
current sequence. Press “Stop” button to stop checking.
5. After you finish sequence setup, press “ESC” to return to the “PTZ” menu. In
“PTZ” menu, press “Confirm” to save the modification.
Please make sure the PTZ you are using can support the sequence function.
6.14.6 Cruise (Pattern) Setup:
Cruise (often referred to as pattern)
“remembers” a pre-selected series of
camera movements. This series of dome
movements will take place when the
Cruise/pattern number is selected.
1. In the “PTZ” menu, select the “Setup”
button to the right of “Cruise.” This will
activate the Cruise setup menu.
2. Select “RecCru” to enter the “PTZ
control” interface. You can control the
PTZ with the direction keys. Press [ENTER] to save the operation track and return to
the “Cruise” setup menu. Press “StartCru” button to repeat the PTZ track until you
press “Stop” button.
3. Select “Return” to return to the “PTZ” menu. In “PTZ” menu, press “Confirm” to
save the Pattern/cruise.
Please make sure the PTZ you are using can support the cruise (pattern) function.