System information

43
2. Select the “Adjust” button for each parameter; Brightness, Contrast, Saturation
and Hue. Press the [ENTER] key to access the parameter overlaid on an image of
the selected camera. Use the [ â ] [ á ] keys to adjust as you watch the image
change. When you are satisfied with the results, press [ENTER] to return “Image
Setup” menu.
3. Repeat the steps above to adjust any
other cameras.
4. Press “Confirm” to save the settings,
or “Cancel” or [ESC] to abort.
6.6 Mask Area Setup (Privacy Mask)
Some cameras may be installed in a sensitive area where it would be advantageous to
mask a portion of the image to prevent viewing and recording. A Privacy Mask can be
applied to any camera. This area will be blacked out on the viewed and recorded
image.
Setup of a Privacy Mask:
1. Enter the “Camera Input Adjustment” menu:
2. Select a camera: Use the [ â ] [ á ] keys to select a camera.
4. Enable the check box next to the “Area” button (press the Edit
key to enable “ü ”).
5. Select the “Area” button and press [ENTER] to enter the mask area setup.
Setup mask area: In the mask area setup interface, there is one small yellow pane on
the upper left side. For PAL cameras, the screen is divided into 22*18 sections. Use
the [ â ] [ á ] [ à ] [ ß ] keys to move the yellow pane to a starting position and