User guide

USER GUIDE

2850ST

■ Unicable Channel Frequency - once you select the Channel

Number the receiver assumes standard frequency for this

number. However, you can change it by editing this option.

■ Unicable LNB - press key on the remote control to gain

access to more advanced conﬁguration of the LNB. Use this

option when you have a non standard LNB.

DiSEqC

DiSEqC control type allows you to connect up to 4 satellite signals.

In this case you need a dedicated DiSEqC switch, controlled by the

receiver, to manage the satellite signals. You can conﬁgure each of

the 4 LNBs by pressing

key on the remote control.

Tone Burst

this control type also known as miniDiSEqC can be used to allow

your receiver to connect to 2 satellite signals, for example to a

dual-feed antennna. You can also conﬁgure each of the 2 LNB by

pressing

key on the remote control.

Please note that one of the LNB must be set to receive

signal from Hotbird satellite. In other case the receiver

will not be able to ﬁnd channels.

FACTORY RESET

If you want to return your receiver’s settings to the default values it

had when you ﬁrst took it out of the box, select Factory Reset. This

restores all original factory settings and cancels all the changes

you have made. To do this select Yes in the Factory Reset screen

and press .

To access Factory reset screen you need to provide PIN code. The

default PIN code is: 1234.