Manual

2
ADVANCED CONTROL TECHNOLOGIES, INC.
Indianapolis, Indiana 46250
240/277 VAC SA4200 LED Lamps Installation Instructions
P/D 111510
Figure 2.
5. Disconnect the line and neutral wires to the ballast, but leave the bare (or green) ground wire connected to
the fixture. Cut the wires from the ballast to the lamp holders.
6. Ballast can remain in place. Check local regulations.
INSTALLATION
WARNING
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp
objects. Do not make or alter any open holes in an enclosure of wiring or electrical components during
kit installation.
NOTE: Connect no more than 5 wires per wire nut.
8. Connect the Neutral wire (usually white) to the wires emerging from the lamp holder on one end of the
fixture using a wire nut (you may need extra wire - use 18 AWG solid wire). See Figure 3.
9. Connect the Line wire (usually black) to the wires emerging from the lamp holder on the opposite end of the
fixture using a wire nut (you may need extra wire - use 18 AWG solid wire). See Figure 3.
Figure 3.
NOTE: Connect no more than 1 wire per lamp-holder terminal. Lamp-holders typically have 4 terminals.
The jumper in figure 3 is only required if the lamp-holder does not have two wires connected or if the
maximum of 5 wires per wire nut would be exceeded. If your fixture does not have a starter, then all
references to "starter" in these instructions may be ignored.
10. Replace the cover over the wiring channel. See Figure 4.
11. IMPORTANT: Install the label provided that states "this fixture has been modified for LED lamps",
inside the fixture in an easily visible location to anyone changing lamps, possibly on the cover over
the wiring channel. See Figure 4.
Figure 4.
12. Install the LED lamps as shown in Figure 5.
Figure 5.
13. Close (or replace) the diffuser.
14. After all LED lamps retrofit is completed, restore the power at the circuit breaker and turn the lights on.