User Manual

Evolve LRM-1000, Series 300, Rel. 5.2 Instructions
P/D 101011
LRM-1000
by Evolve Guest Controls
4
SPECIFICATIONS
Power 120 VAC, 60 Hz.
Maximum Load 1000W, incandescent lamps only.
Signal (Frequency) 908.42 MHz.
Range Up to 100 feet line of sight between the Wireless Controller
and /or the closest HomePro Receiver Module.
INTER-OPERABILITY WITH EVOLVE™ DEVICES
An Evolve™ network can integrate devices of various classes, and these devices can be made by different
manufacturers. The LRM-1000 can be incorporated into existing Evolve™ networks.
The top or bottom of the LRM-1000 switch can be used to carry out inclusion or exclusion.
WARRANTY
For warranty and general product information visit our web site at www.eguestcontrols.com
ABOUT LRM-1000’S CERTIFICATION
The LRM-1000 is certified to comply with applicable FCC and IC rules and regulations governing RF and EMI
emissions.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this
equipment. Such modifications could void the user authority to operate the equipment.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
IC NOTICE
This Class B digital apparatus complies with Canadian
ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maxi-
mum (or lesser) gain approved for the transmitter by Industry Canada,. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne
d’un type de d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire
les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son
gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à
l’établissement d’une communication satisfaisante.