User Manual

Z-Wave ZDW120 Instructions, Series 300, Release 3.10
P/D 060210
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0795-01
5
SPECIFICATIONS
Power 120 VAC, 60 Hz.
Signal (Frequency) 908.42 MHz.
Minimum Load 40W, incandescent lamps only.
Maximum Load 500W, incandescent lamps only.
Range Up to 100 feet line of sight between the Wireless Controller
and /or the closest HomePro Receiver Module.
Operating Temperature Range 32-104
O
F (0-40
O
C). Indoor use only.
INTER-OPERABILITY WITH Z-WAVE™ DEVICES
A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different
manufacturers. The ZDW120 can be incorporated into existing Z-Wave™ networks.
The top or bottom of the ZDW120 switch can be used to carry out inclusion, association, or exclusion.
WARRANTY
For warranty and general product information visit our web site at www.act-solutions.com
ABOUT ZDW120’S CERTIFICATION
The ZDW120 is certied to comply with applicable FCC and IC rules and regulations governing RF and EMI emissions.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that
may cause undesired operation.
FCC NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
IC NOTICE
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.