User Manual

Evolve Guest Controls LRM-20 Instructions

LRM-20

by Evolve Guest Controls

Proper Single Gang Installation

Using LRM-20’s standard full heat-sink (all tabs), the connected incandescent lamp load shall not exceed 500W.

If a tab is removed from one side of the LRM-20 unit, the connected incandescent lamp load must not exceed 400W.

If both tabs are removed from the LRM-20 unit, the connected incandescent lamp load must not exceed 300W.

Proper Dual Gang Installation

The connected incandescent lamp load must not exceed 400W for each of the two LRM-20 units.

Proper Triple Gang Installation

The connected incandescent lamp load must not exceed 300W for each of the three LRM-20 units.

Air Gap Switch

The LRM-20 has an air gap switch on the face (lower left), that when pulled out, completely removes the power available to

the load (simply turning the dimmer off does not). This enables the lamps that are controlled by the device to be changed

with minimal danger of electrical shock. The air gap switch must be pushed all the way back in for the dimmer to operate

the lamps again.

. Prepare the Controller to include a unit to the network by adding it to a group (method of adding a node to the network).

Refer to controller instructions.

LRM-20 Tap either the top or bottom of the LRM-20 switch once.

You should see an indication on your Controller that the “DEVICE WAS INCLUDED” in the network.

it may be that the Home ID and Node ID were not cleared from it after testing. You must ﬁrst “RESET UNIT” with your

controller to remove it from the network. If using the EHC-100 select “SETUP” and scroll to “RESET UNIT”

Although adding it to a group includes it in the network, removing it from a group does not remove it from the network. If

removed from a group, it functions only as a repeater.

Local Control

The top or bottom of the LRM-20 switch can be used to carry out inclusion (add to a group), association, exclusion (remove

from group) or reset (remove from network).

Pushing the top or bottom of the switch, the LRM-20 allows the user to do the following:

• Turn ON, OFF, DIM or BRIGHTEN the load attached.

• Include or exclude the module from the EvolveNet network.

Conﬁgure to Control Shades or Window Coverings via EvolveNet network.• Control other EvolveNet enabled devices.

Also, when a controller prompts you to “Send Node ID” or to “Press Button on Unit”, quickly tap the top or bottom of the

switch once to satisfy those instructions.

• Tapping top of the switch turns the load attached ON.

• Tapping bottom of the switch turns the load attached OFF.• Pressing and holding the top of the switch will brighten

the load attached, and pressing and holding the bottom of the switch will dim the load. When OFF, pressing and

holding the bottom of the switch will cause the load will go to the minimum dim level.

Note: Upon restoration of power after a power loss, the LRM-20 returns to previous known state.

LED indication

The LED on the LRM-20 will turn on when the load attached is ON. However, the LED can be user conﬁgured to turn ON

when the load attached is OFF, if so desired, to act as a night light.

The LRM-20 will ﬂicker its LED when it is transmitting to any of its groups. This can be changed if desired.

Remote Control

The LRM-20 will respond to BASIC and MULTILEVEL commands that are part of the EvolveNet system. Refer to your control-

ler’s instructions as to whether your controller can transmit those commands.

All On/All Off

The LRM-20 supports the ALL ON/ ALL OFF commands.