User's Manual

Evolve LRF-20 Instructions, Release 5.1

P/D 092610

EvolveNet

by EVOLVE GUEST CONTROLS

Radio Frequency (RF) Controlled, 120 VAC, Scene Capable,

Isolated Contact Fixture Module, Release 5.1, 300 Series

LRF-20 ISOLATED CONTACT FIXTURE MODULE

The LRF-20 Isolated Contact Fixture Module is a component of the Evolve lighting control system. Wire the Isolated

Contact Fixture Module according to the diagram above and program it from the Wireless Controller to operate

loads. Inclusion of this Switch on the EHC-100 Wireless Controller menu allows remote ON/OFF control of load

connected.

This Isolated Contact Fixture Module is designed to work with other Z-Wave enabled devices. Z-Wave nodes of

other types can be included on the network and will also act as repeaters if they support this function.

As part of a Z-Wave network, the LRF-20 will also act as a wireless repeater to insure that commands intended

for another device in the network are received. This is useful when the device would otherwise be out of the radio

range of the wireless controller.

There are no ﬁeld repairable assemblies on this unit.. If service is needed, the unit must be returned where purchased.

DANGER! SHOCK HAZARD. Read and understand these instructions before installing. This device is intended

for installation in accordance with the National Electric code and local regulations in the United States, or the

Canadian Electrical Code and local regulations in Canada. It is recommended that a qualiﬁed electrician perform

this installation.

For indoor use only. Retain instructions for future use.

INSTALLATION

Wire this module in series with a (maximum) 20 amp load according to the diagram above.

AS101’s are required to be wired to the same line (or neutral) which is also wired to the master unit as well

as the load being controlled, and not wired to any other neutral. If multiple neutrals are tied together in one box,

separate the neutrals to preserve the integrity of the LRF-20 circuit. See the EHC-100 Wireless Controller operat-

ing instructions to include this module under the command of the Wireless Controller.

Fixture Mounted Conﬁguration

Push the button on the face to conﬁgure the module to operate from the wireless controller (see EHC-100

instructions). With the Wireless Controller, the LRF-20 can be switched ON and OFF remotely, and can be

LRF-20

PAGE 1
LRF-20 Radio Frequency (RF) Controlled, 120 VAC, Scene Capable, Isolated Contact Fixture Module, Release 5.1, 300 Series LRF-20 Isolated Contact Fixture Module The LRF-20 Isolated Contact Fixture Module is a component of the Evolve lighting control system. Wire the Isolated Contact Fixture Module according to the diagram above and program it from the Wireless Controller to operate loads. Inclusion of this Switch on the EHC-100 Wireless Controller menu allows remote ON/OFF control of load connected.
PAGE 2
included in groups of lights that operate at the same time (a group can also be a single module), and in scenes that set a lighting mood. Switch power ON and OFF with Auxiliary Switch The LRF-20 can also be controlled from an AS101 ver.2 auxiliary switch in another location. A second AS101v2 (maximum is two) can be wired in parallel with the first to create 4-way control. Other functions The button on the LRF-20 also plays a role as a reset in addition to including the module in groups and scenes.
PAGE 3
Specifications Power: 120 VAC, 50/60 Hz Signal (Frequency): 908.42 MHz Maximum Load Isolated Contacts: 20 amps G.P. maximum, 277 VAC, 10FLA, 60LRA, 250VAC, Motor: 1 H.P.