User's Manual

ZDP100 Instructions
071202
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
2
Child Protection
The Lamp Module can be set in a child protect mode by the Remote Transmitter (see section 4.4 of Remote
Transmitter instructions). When this mode is active, a user will have to press the button on the Lamp Module 3 times
rapidly to activate the attached load. The module operates normally when controlled by the Remote Transmitter.
Other functions
The button on the Lamp Module also plays a role when resetting and adding to groups and scenes. This is described
in more detail in Section 4.2 and 4.2.2 of the Remote Transmitter instructions.
Software fuse
This Lamp Module is designed to protect itself against loads that exceed it’s maximum power rating. The
application of a load that exceeds that rating is quickly sensed by the dimmer and it responds by immediately
shutting off all power to that load.
If the dimmer doesn’t seem to work, or if it only works momentarily, check to see that the total lamp wattage doesn’t
exceed the 300W rating of the Lamp Module. If a properly sized load is restored to the dimmer, it can be operated
normally once again.
Over-current protection
The Lamp Module hardware has an over current detection circuit, which is final protection against overload.
If the software fuse should fail to shut down the dimmer when overloaded, backup protection is provided by an
internal fuse. This fuse is not user serviceable. Check your home circuit breakers before concluding that the
product must be returned to manufacturer for repair at a nominal charge.
Operation Note
When a light bulb reaches the end of it’s life and burns out, it sometimes creates a momentary short circuit. The
high current that results may cause the dimmer to properly respond by turning off. Should this happen, replace
the bulb with a new one. The dimmer can now be operated to restore power to the light.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by one or more of the following mea-
sures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC NOTICE