User's Manual
ZDW120 Instructions
P/D 100504
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0671-01
7
Power 120 VAC, 60 Hz.
Signal (Frequency) 908.42 MHz.
Maximum Load 600W, for incandescent lamps only.
Range Up to 100 feet line of sight between the Wireless Controller and /or the closest
HomePro Receiver Module.
Operating Temperature Range 32-104
O
F (0-40
O
C). Indoor use only.
SUC Support
There must be a Static Update Controller in your Z-Wave system for this feature to work. A Static Controller is
one that is not moved after addition to the network. The Static Controller can act as a gateway in the system, since
other nodes always know its position. The “always listening” advantage of the Static Controller is that other nodes
can transmit information frames to it whenever needed.
You can assign an “SUC Route” to the ZDW120. Refer to your controller’s instructions on how to do this (if it
supports it). Assigning an SUC Route to the ZDW120 allows the ZDW120 to request an update of the Z-Wave
devices that are in between it and the Z-Wave device it was trying to transmit to. The ZDW120 will only request
an update when a transmission fails.
WARRANTY
For warranty and general product information visit our web site at www.act-solutions.com
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
IC NOTICE
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.
About ZDW120’s Certification (Pending)
The ZDW120 has been thoroughly tested by the ETL SEMKO
division of Intertek, a nationally recognized testing laboratory. This
product was found to be in compliance with safety standards
ANSI/UL STD 1472 and CAN/CSA C22.2 No. 184.1.
In addition to compliance with product safety standards, the
ZDW120 is also certified to comply with applicable FCC and IC
rules and regulations governing RF and EMI emissions.
Manufacturer ID 1 0x00
Manufacturer ID 2 0x17
Product Type ID 1 'D' or 0x44
Product Type ID 2 'W' or 0x57
Product ID 1 '2' or 0x32
Product ID 2 '0' or 0x30