User Manual
Table Of Contents
- ABBREVIATIONS
- INTRODUCTION
- PRODUCT DESCRIPTION
- HW SPECIFICATIONS
- SW SPECIFICATION
- REFERENCES
DSH, Datasheet 903501205 May 1, 2003
Zensys A/S ZM1220 Z-Wave Module Page 12 of 15
CONFIDENTIAL
4.12 Electrical Specification
4.12.1 Absolute Maximum Ratings
The “Absolute Maximum Ratings” specifies the conditions in which the Z-Wave Module is guaranteed not
to be destroyed but correct operations are not guaranteed. Exceeding the “Absolute Maximum Ratings”
may destroy the Z-Wave Module. See “DC Characteristics” for guaranteed operation limits.
Electrical Value
Operating Temperature
-30°C to +100°C
Storage Temperature -40°C to +105°C
Voltage on input pins -0.3V to V
CC
+0.3V (5V max)
Minimum Operating Voltage (V
CC
) -0.3V
Maximum Operating Voltage (V
CC
) 5V
Maximum Operating Voltage (5V) 20V
DC Current per GPIO Pin
±4mA
Table 6 Absolute Maximum Ratings
4.12.2 DC Characteristics
The following DC characteristics are for the Z-Wave Module. DC characteristics related to the ZW0102
Single Chip are to be found in [1] and are not listed in this datasheet.
T
A
= 25°C, V
CC
= 3.3V (unless otherwise noted)
Symbol Parameter Condition Min Typ Max Units
V
CC
Main Supply voltage
(1)
(Max. 20mVpp ripple from
DC to 300kHz)
2.7 3.3 3.6 V
5V
5V Supply voltage
(2)
(for DC/DC Converter)
Max. 50mVpp ripple from
DC to 300kHz
Max. 100mVpp ripple
>300kHz
3.6 18V V
RRST Reset Pull-up Resistor Integrated in ZW0102 48 60
kΩ
R
AC
Application Connector
Serial Resistor
All signals except TRIAC 0.9 1.0 1.1
KΩ
Transmitting
(Xtal: 7.376974 MHz)
-5dBm, V
CC
= 3.3V
-2dBm, V
CC
= 3.3V
0dBm, V
CC
= 3.3V
+2dBm, V
CC
= 3.3V
+4dBm, V
CC
= 3.3V
22.9
24.5
26.6
25.5
30.0
mA
Receiving
(Xtal: 7.376974 MHz)
V
CC
= 3.3V,
26 mA
Power Down
V
CC
= 3.3V, RTC running,
Power-on-reset disabled
35
µA
I
CC
Power Down
Power-On-Reset and
DC/DC converter not
mounted, V
CC
= 3.3V,
temp.= 25°C, Power-on-
reset disabled
1
µA
T
OP
Operating
Temperature
-10 85
°C
H
OP
Operating Relative
Humidity
8 80 %
(1) When integrated Reset circuitry is enabled min. supply voltage is 3.1V
(2) Required when DC/DC converter is mounted on Z-Wave Module
Table 7 DC Characteristics