ACR890 All-in-One Mobile Smart Card Terminal User Manual V1.00 Subject to change without prior notice info@acs.com.hk www.acs.com.
Table of Contents 1.0. Introduction ............................................................................................................. 3 1.1. Typical Applications ............................................................................................................... 3 2.0. ACR890 Overview .................................................................................................... 4 2.1. 2.2. 2.3. 2.4. 2.5. Parts Description ..................................................
1.0. Introduction The ACR890 All-in-One Smart Card Terminal is the next generation mobile smart card terminal that combines smart card, magnetic stripe and contactless card technologies. It has GPRS functions for mobility and an A8 core for power and faster performance. Having a touch screen capability allows interactive operation through the terminal’s screen interface. It also includes a built-in printer which is ideal for performing faster transactions.
2.0. ACR890 Overview 2.1. Parts Description The main components of ACR890 All-In-One Smart Card Terminal are shown below: Figure 1: ACR890 – Parts Description Page 4 of 7 ACR890 – User Manual Version 1.00 www.acs.com .hk info@acs.com.hk www.acs.com.
2.2. Inserting/Changing the battery ACR890 runs on a rechargeable Li-ion battery (7.4 V, 2000 mAh), located at the back of the device. To insert/change the battery: 1. Remove the battery cover (see Error! Reference source not found.). 2. Insert the battery with the contacts aligning to the terminal of the device. 3. To change the battery, lift the Li-ion battery out of the slot to replace with a new one. Figure 2: ACR890 – Changing the Battery 2.3. Turning the power on/off 1.
2.4. Inserting memory/module cards ACR890 has one (1) Micro SD card slot, (1) SIM card slot and two (2) SAM card slots located at the back of the device. To insert or change SAM cards: 1. Remove the battery. 2. The location of the Micro SD Card, SIM and SAM slots can be seen in Figure 3. 3. Slide the card slot to open it. 4. Insert the card. 5. Slide the card slot back into place to close it. Figure 3: ACR890 – Location of Card Slots Page 6 of 7 ACR890 – User Manual Version 1.00 www.acs.com .
2.5. Placing the paper roll The ACR890 has a built-in thermal printer located on the upper part of the device where the contactless interface is also located. To place the paper roll: 1. Carefully lift the tab of the printer cover (see Figure 4). 2. Place the paper roll following the proper paper orientation (see Figure 5). 3. Close the printer cover. Figure 4: ACR890 – Opening the Printer Figure 5: ACR890 – Paper Orientation Page 7 of 7 ACR890 – User Manual Version 1.00 www.acs.com .hk info@acs.com.
4.0. FCC Caution FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
