Operation Manual

26 Naída CI Sound Processor User Guide
If the user would like to know the battery status of the Zn-Air Battery Pak they are currently
using and have an AB myPilot paired to their device, they can conduct a Battery Check readout
of the Naída CI. To ensure an accurate reading of the Zn-Air Battery Pak, wait at least 15
minutes after it has been attached to the Naída CI before performing a Battery Check readout.
Please see the Battery Check section of the AB myPilot User Guide for instructions on how to
conduct a battery status check using AB myPilot.
Understanding Internal Alarms
Internal alarms are a programmable feature that can be used independently or in conjunction
with the Naída CI LEDs to provide important information about Naída CI status and battery life.
Naída CI Internal Alarms
Using the Naída CI Headpieces:
The Naída CI works with the Universal Headpiece (UHP)
The Universal Headpiece
The UHP is designed for use with the Naída CI processor during all daily activities, with the
exception of swimming and bathing.
Replacing RF Cables
RF cables are available in a variety of colors and lengths to suit the recipient’s personal wearing
preferences. Before you can use the Naída CI sound processor, you must use the cable to
connect it to the headpiece. Inspect the cable on a regular basis to ensure it is in good condition.
Behavior Programmable Indication
Beeps upon
program change
Yes • 1 beep indicates program one
• 2 beeps indicate program two
• 3 beeps indicate program three
• 4 beeps indicate program four
• 5 beeps indicate program five
Short Beep upon
increase/decrease
in volume
Yes Beeps once per press of the volume control
either up or down (a double beep will be heard
when the following settings are reached: top of
the volume range; baseline volume setting; and
bottom of the volume range)
Long Beep (once
every 15 minutes)
Yes Low battery